Schedule 1 Amendments
(section 3)
[1] Subsection 5 (1), after definition of EN 50361
insert
EN 62209‑1 means Human exposure to
radio frequency fields from hand‑held and body‑mounted wireless
communication devices — Human models, instrumentation, and procedures —
Part 1: Procedure to determine the specific absorption rate (SAR) for hand‑held
devices used in close proximity to the ear (frequency range of 300 MHz to 3
GHz), published by the European Committee for Electrotechnical
Standardisation (CENELEC).
Note EN 62209‑1 is a European Union
harmonised standard based on IEC 62209‑1, a standard developed by
Technical Committee TC106 of the International Electrotechnical Commission (IEC).
Australia has active representation on TC106 through the participation of
Standards Australia (http://www.standards.org.au/).
[2] Subsection 5 (1), definition of old standard
substitute
old standard means the Radiocommunications
(Electromagnetic Radiation — Human Exposure) Standard 2003 as in force
immediately before 1 April 2007.
[3] Subsection 5 (2)
substitute
(2) A reference in this Standard to a publication or
other document of:
(a) Standards Australia; or
(b) the British Standards Institution; or
(c) the European Committee for Electrotechnical
Standardisation;
includes a reference to the publication or other document as in
force from time to time.
[4] Section 6, heading
substitute
6 Application
of Standard: general
[5] Paragraph 6 (1) (a)
omit
1 March 2003,
insert
1 April 2007,
[6] Section 7, including the notes
substitute
7 Transitional
arrangements on and after 1 April 2007
On and after 1 April 2007, the old standard
continues to apply to a mobile station if:
(a) the device is not
equipment to which this Standard applies under section 6; and
(b) the old standard
applied to the device immediately before 1 April 2007.
Note 1 The continued application
of this Standard to a device under this section is not relevant to the
definition of non‑standard device in section 9 of the Act
because the status of the device (as standard or non‑standard) was
established when the device was last manufactured, imported, altered or
modified.
Note 2 For paragraph (a)
a device that was manufactured, imported, altered or modified before 1 April 2007
is equipment to which this Standard does not apply under section 6.
[7] Section 8
omit
[8] Subsection 9 (1)
omit
or 8 (1)
[9] Subsection 9 (2)
omit
or 8 (1)
[10] Subsections 10 (2) and (3)
substitute
(2) Before 1 March 2009, the measurements to determine
if the aware user device or non‑aware user device meets the standard for
performance of subsection 9 (1) or 9 (2) are the measurements in EN 50361,
Schedule 2 or EN 62209‑1.
(3) On and after 1 March 2009, the measurements to
determine if the aware user device or non‑aware user device meets the
standard for performance of subsection 9 (1) or 9 (2) are the measurements in
EN 62209‑1.
[11] Section 12, heading
substitute
12 Assessment methods for performance
standards: aware user devices and non‑aware user devices more than 20cm
from the human body
[12] Subsection 12 (2)
omit
measured
insert
assessed
[13] Subsection 12 (3)
omit
measured
insert
assessed
[14] Subsection 12 (4)
omit
measured
insert
assessed
[15] Schedule 1
omit